Our crews are certified, insured and equipped for crawl space water removal. They find the hidden moisture and dry it properly.
The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
You focus on your home. We put together the photos, readings and reports your insurance company needs.
Most people who call us have never dealt with crawl space water removal before. We walk you through it on the phone, then send a local crew with the right equipment.
Water under the house is easy to miss. It tends to turn up as a damp chill underfoot, a stale smell at the vents, or a small lake discovered the day somebody lifts the hatch. Usually that means days of moisture in the joists already, plus insulation that is wet all the way through. Crews from our company extract the water, haul away anything that cannot be saved and dry the structure ahead of rot.
Getting the water out is only the first half. Wood framing takes water in gradually and gives it up just as gradually, which is why we meter the joists, beams and subfloor and leave dehumidifiers on until readings drop, typically 3 to 5 days. Finding the cause matters just as much, since a dripping water line, a failed drain or groundwater from a storm will flood the area again unless it is addressed.
Water collects in the low spots and soaks into the soil. Humidity in the space jumps within hours as the insulation pulls water into itself.
Paper faced insulation and moist joists are where mold is able to appear first. The weight of the water drags the batts loose from the underside of the subfloor.
Humid air from below works its way up into the rooms. The lumber goes on taking in moisture, a stale smell spreads and flooring can begin to cup.
Lumber left damp this long starts breaking down. Sill plates and joists lose firmness, nails and hangers corrode, and termites along with other pests move toward the moisture.
When the ground stays soaked, footings may lose support and piers can tilt or sink. Sloping floors or sticking doors in the rooms above may point to this.
Do not assume the water below your floor is clean. Groundwater full of soil and waste, or a drain leak, counts as Category 2 or 3, which calls for protective equipment and disinfecting.
Most crawl spaces carry wiring, junction boxes and HVAC ducts. When duct insulation is saturated it sends stale air around the home, while flooded wiring creates a real risk of shock.
Rot often starts on top of the joist or at the sill plate, where you cannot see it from the hatch. Our crew tests the lumber by hand to locate weak areas.
We check for electrical hazards, sagging ducts and contaminated water before anyone crawls in. Then we map how far the water reached and take moisture readings on the joists and subfloor.
We run pumps and extraction lines until the pooled water is gone, low pockets and trenches along the footings included. Any silt or mud sitting on the liner gets removed during this step.
We bag up the wet insulation, damaged vapor barrier and loose debris and take it all outside. Our crew then wipes down the uncovered framing and applies antimicrobial to spots with growth or a high chance of it.
A dehumidifier and low profile air movers stay running beneath the floor until the lumber meters at a normal level. You get the closing moisture readings plus a plan for keeping water out, after we verify everything by meter.
It depends on the material, how long it stayed wet and how clean the water was. We test before we decide, and we tell you why.
Ask a Tech: (972) 666-5860| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Pipe insulation | Rubber or foam wrap that stayed out of the water | Fiberglass wrap or any sleeve that sat in dirty water |
| Floor joists | Solid wood that is wet but firm when probed | Soft, crumbling or deeply rotted sections that no longer carry load |
| Sill plates | Wood that reads dry on the meter and resists a probe | Stretches that are soft, crushed or eaten through by rot |
| Subfloor panels | Flat plywood with no puffed edges that still grips fasteners firmly | Panels that puffed up, split into layers or crumble, particle board above all |
| Ductwork | Rigid metal duct that hung higher than the flooding | Flexible ducting and duct wrap that were submerged |
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (972) 666-5860Take action now and prevent costly damage. Hamilton Restoration is ready to help.
Call (972) 666-5860 Now