Every technician is IICRC certified and has handled wet carpet drying many times. You get a clear plan before any work starts.
The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
You focus on your home. We put together the photos, readings and reports your insurance company needs.
You do not have to work out how bad it is on your own. Call, tell us what you see, and a Hamilton technician will explain the next step and what it should cost.
Carpet holds far more water than it looks like it does. The face fibers can feel only damp while the pad underneath is soaked like a sponge and the subfloor below it is wet too. A shop vacuum and a stack of towels only deal with the surface. In Hamilton, we pull the water out, take moisture meter readings on each layer, and place drying equipment that works down to the subfloor.
Saving a carpet comes down to how long it stayed wet and whether the water that soaked it was clean. Carpet soaked by a clean supply line can usually be dried in place if we get to it quickly. With an appliance leak, which is gray water, we often discard the pad, then clean and treat the carpet. Sewage or outside flood water means carpet and pad both come out.
It depends on the material, how long it stayed wet and how clean the water was. We test before we decide, and we tell you why.
Ask a Tech: (972) 666-5860| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Baseboards | Solid wood that dries flat and stays tight to the wall | Fiberboard trim that puffed up, or any board with mold behind it |
| Carpet pad | Only a small section got wet, from clean water, and drying begins that day | Gray or black water, or soaked for more than a day or two |
| Plywood subfloor | Solid underfoot and dries back to a normal moisture reading | It has gone soft in places, grown mold on top, or started delaminating |
| Tack strip | Nails are rust free, the wood is not swollen, and it got wet briefly | Any rust, mold or swelling, or contact with dirty water |
| Carpet | Backing is firmly bonded, the water was clean, and it sat under two days | The backing is coming apart, or it took in flood water or sewage |
Thermal imaging and meter readings show us where the water went, closets and the space under walls included. Then we determine which category of water it is, as that tells us what is safe to keep.
We use weighted extraction tools that squeeze water from carpet and pad at once. This removes far more than a wand alone, and it shortens the drying time that follows.
The carpet is either pulled back so the pad can go, or left down with air blown beneath it, whichever the job needs. Dehumidifiers and air movers stay on until the subfloor and the carpet each test dry.
Where needed, an antimicrobial goes on the subfloor and carpet, then new pad is laid if the old was removed, and the carpet is stretched back on its tack strip and cleaned.
Furniture legs sitting on wet carpet release wood stain and rust into the fibers. Such spots are frequently there for good, while the legs soak up water and swell.
The dark, damp underside of the carpet is where mold usually begins. You smell it long before you ever see it on top.
Particleboard and OSB under carpet swell and crumble when they stay wet. Weeks later, with the spill long forgotten, you get raised seams, squeaks and soft spots.
Water that started clean does not stay that way. As it sits in carpet and pad it picks up soil and bacteria, so a carpet that could have been dried may have to be removed.
Under the surface, the pad pulls water outward, well beyond what looks wet. The tack strip starts taking on water as it creeps below the walls toward the room next door.
Bacteria in the damp pad start producing that sour wet carpet smell. Mold can start to grow on dust caught deep in the pile and on the carpet back.
The latex that holds the backing together breaks down, so the carpet delaminates and ripples. The subfloor swells and the tack strip nails begin to rust.
At this stage, removing both carpet and pad is usually the only option. Mold has often reached the subfloor and the bottom of the drywall, so the job grows.
Have a different question? Call us and we will answer it over the phone.
Call (972) 666-5860Take action now and prevent costly damage. Hamilton Restoration is ready to help.
Call (972) 666-5860 Now